Medical door manufacturers discuss potential issues and solutions when using medical doors.

　　The medical door manufacturer talks about the possible problems and solutions when using medical doors.

　　Medical door manufacturer: Possible problems and solutions when using medical doors.

　　The medical doors produced by the medical door manufacturer are mainly used in public spaces of hospitals. Hospitals are environments with a lot of bacteria. Given the special nature of hospitals, where the flow of people is large and dense, collisions are likely to occur. Therefore, the existence of medical doors is not just as doors, but also plays a good protective role. During the use of medical doors, failures may occur, making them unusable. What are the common failures?

　　1. When the medical door is operating, the door is always open or does not open at all. The main reasons are power failure, poor electrical connection, interference from foreign objects causing the green flashing open signal, leading to the door being stuck open or not opening at all. Another reason is the incorrect selection of the opening direction.

　　2. When the medical door is operating, the opening or closing action is too slow. This is mainly due to the set value of the opening or closing speed knob of the control device being too low; excessive walking resistance, loose belt, insufficient tension, etc. The speed knob for opening or closing can be adjusted accordingly; turn off the power, move the door leaf by hand, and check if there are any obstacles in the moving parts; adjust the belt tension.

　　3. Over time, the medical door may cause increased friction of the rubber strip, resulting in abnormal sounds. We can change the distance between the ground wheel and the three-frame upright to increase the distance between them. At the same time, adjust the hanging wheel to position the door body so that it does not rub against the rubber strip. If this does not solve the problem, a smaller size silicone strip can be replaced.

　　4. The three areas that are prone to abnormal sounds: friction between the track and the wheel, the ground wheel under the door body, and friction between the rubber strips. The solution to the abnormal sounds caused by rubber strip friction has been mentioned above. As long as the friction between the track and the wheel does not remain in the original position for a long time, dust can easily accumulate, leading to friction between the track and the wheel. The solution is to add some lubricant. The abnormal sound from the ground wheel is caused by friction between the door body and the ground wheel, which can be resolved by positioning the ground wheel directly under the door body.

　　5. If it is a problem with the control unit, replacing the controller and motor is necessary for normal operation.

　　Medical door manufacturer: Four conditions that must be met before the medical door is put into use.

　　1. Wear-resistant: Because some children are lively and active, they like to run around in the ward and use things to slide, the doors in hospitals need to be more wear-resistant.

　　2. Environmentally friendly: Children and adolescents are in a developmental stage and have a weaker resistance to harmful substances. Therefore, the environmental protection requirements for the decoration of hospital indoor spaces are very high. When purchasing hospital-specific doors, attention should be paid to the environmental protection level of the hospital-specific doors, choosing products with an environmental protection level of E0 to reduce the harm of decoration pollution to children.

　　3. Soundproof: If children are noisy, to avoid affecting the neighbors' lives, choose hospital-specific doors with good soundproofing effects.

　　4. Easy to clean: Hospital-specific doors should be easy to clean, without concave and convex patterns and seams, which may pose a potential threat to children.

　　The above is the content explained by the editor of the medical door manufacturer, hoping it is useful to everyone.