What are the precautions for installing an induction door?

With the progress of the times, technology is also constantly developing, and this induction door is favored by everyone. Below are some points to note when installing an induction door. If you are also interested in this topic, let's take a look together.

What everyone needs to know about installing an induction door is the installation of the aluminum alloy shell beam: when installing the beam, it must be kept parallel, with an error within1millimeters. If the aluminum alloy shell beam is not flat, the induction door will have uneven strength during movement, directly shortening its lifespan. After the door body hanging parts are installed, use another door body hanging bolt to install the hanging device in a specific area of the door body. It is important to know that the center of the pulley should be parallel to the door body during installation. If it is not flat, it will directly shorten the lifespan of the pulley. Then hang the pulley on the power beam, but be careful not to damage the components and guide rails inside the power beam during installation, otherwise, the pulley may produce noise and other abnormal sounds. These should also be noted. Next is the limiter. First, slightly loosen the bolts of the limiter, then accurately insert the limiter into the guide rail of the power beam. However, during installation, first determine the opening and closing state of the induction door to locate the position of the limiter, and then use a hex wrench to secure the bolts.

After the induction door is installed, the height and gap position of the door body should be adjusted to the best state. For example, you can use adjustable brackets to fix the nuts to ensure that the induction door does not make strange noises during movement. Additionally, it is important to secure all pressure plates in place with bolts to adjust the tension of the belt, as the belt is always in a tensioned state when the door moves. Secondly, when installing the ground wheels, ensure that the gap size above and below the door body is consistent. It should be understood that if the operating system fails, first manually check the door body, turn off its operating switch, and then adjust the direction and speed of the door. Secondly, the installation of the induction probe should be adjusted to the best angle, avoiding contact with the antenna. Of course, during installation, the center of the bracket device's pulley should be parallel to the door body. If it is not parallel, it will shorten the lifespan of the pulley. The pulley of the hanging device is suspended on the power beam. Do not damage other components and guide rails inside the power beam when installing the induction door, otherwise, it will naturally lead to component failure or issues such as pulley lifespan, noise, and abnormal sounds.

The above article discusses the points to note when installing an induction door, and it also shares a relatively good manufacturer of induction doors. If you have such needs, you can check it out, hoping it can help you.