Ningbo Automatic Door Manufacturer: Key Points for Purchasing Sensor Doors

Ningbo Automatic Door Manufacturer: The main feature of the sensor door is that the control system for opening and closing the door is achieved through sensing. "Sensing" refers to the method of opening the door in automatic doors. Sensor doors are widely used in stores, hotels, and enterprises. A characteristic of a glass door is that it will automatically open when a person or object approaches; sensor doors can be roughly divided into sliding, rotating, and push-pull types, among which sliding and rotating types are suitable for setting sensors.

Ningbo Automatic Door

Ningbo Automatic Door Manufacturer: Key points for purchasing sensor doors:

1. Sensor:

Ningbo Automatic Door Manufacturer: In hotels and office buildings, high-sensitivity sensors can be chosen; in banks and stores on pedestrian paths where people frequently pass, narrow area sensors should be selected.

2. Safety auxiliary devices:

Ningbo Automatic Door Manufacturer: In places like hotels, to prevent incidents of the sensor door pinching people, it is advisable to install anti-pinch infrared sensors.

3. Install access control systems and electric locks:

Installing sensor doors in self-service banks can enhance the installation of access control systems and electric locks, thereby controlling entry and exit.

4. Equip with backup power:

To ensure that the sensor door can operate normally during a power outage, a backup power supply can be equipped.

Ningbo Automatic Door Manufacturer: How to install sensor doors

The installation methods and details of different types of sensor doors vary, but the general steps are similar. Now, taking electronic sensor doors as an example, the installation and precautions are as follows:

1. When installing the horizontal aluminum alloy door beam, be sure to keep it level; otherwise, the electronic sensor door will have uneven working intensity after installation, which will increase the rate of door damage.

2. For installing the door hanger, use the door hanger bolt assembly to install the door hanger. Ensure that the center of the pulley is parallel to the door body. During the installation process, do not touch other components inside the power beam. The components of the power beam and the guide rail.

3. Ningbo Automatic Door Manufacturer tells you to install the limit device, adjust the limit bolt, and install the limit device on the power beam guide rail.

4. Adjust the height of the door body and the gap of the door body by adjusting the fixed nut of the hanger. The state of the door body needs to be checked during walking and moving. There should be no friction noise.

5. Adjust the tension of the belt, tighten the tensioning device to the left, and keep the belt in a tensioned state at all times during the tensioning process, then tighten all the pressure plate bolts and loosen the fixed bolts.

6. Install the ground wheel: After installation, ensure that the gaps above and below the door body are consistent to prevent damage to the ground wheel.

7. Ningbo Automatic Door Manufacturer tells you to adjust the control system. Generally, there is no need to adjust the control system. As long as the factory settings are maintained, it can work. If we want to adjust the control system, we need to check the manual door before adjusting to see if it can work smoothly, and then perform the switch operation. Depending on the opening direction of the door body, set it to open to the left or right; adjust whether the opening speed is in the middle and whether the buffer distance is in the middle; adjust the buffer distance when opening the door. Adjust the opening speed.

8. Install the probe, turn on the sensor, then install the sensor and adjust the probe, selecting the appropriate probe angle based on the surrounding environment. During the adjustment process, do not touch the antenna to avoid issues that may cause the electronic sensor door to malfunction.

9. Power the door body, ensuring there are no obstacles during the process.