1. When the automatic induction door is operating normally, this mode stops when the automatic induction door opens to avoid being squeezed by the automatic induction door. Children and the elderly should pay special attention to this. Therefore, when installing and using the automatic induction door, it is necessary to fully consider the monitoring blind spots of the automatic induction door sensors and try to use larger area and more agile microwave sensors.

   
   

2. 

　　When the automatic induction door is closing, it should not be forcibly opened or passed through to avoid being crushed by the automatic induction door. It would be better to install infrared anti-pinch color code sensors.

　　The motor, intelligent controller, and sensors of the automatic induction door must not come into contact with water when cleaning the automatic induction door to avoid safety accidents caused by leakage of the power switch. It is necessary to disconnect the power switch.

　　Children are not allowed to play around the automatic induction door to prevent accidents such as crushing children.

　　Whenever we need to load or unload goods, the power switch of the automatic induction door should be turned off. If the automatic induction door has a remote control, press the normally closed button when the automatic induction door opens.

　　When the automatic induction door is operating normally, this mode is good at pushing the door or colliding with the door leaf to prevent the door leaf from breaking its track.

　　Hard objects should not be placed around the automatic induction door to prevent friction and collision with the door leaf. If something is placed between the moving door leaves of the automatic induction door, the automatic induction door will repeatedly test in the same place back and forth. If the check block has not been removed, the automatic induction door will temporarily stop working. After the temporary human factors check confirms that the block has been removed, under normal circumstances, the reset button on the remote control will be pressed again.

　　The automatic induction door cabinet should be kept clean to prevent impurities and dust from damaging the track and moving pulleys, jeopardizing the lifespan of metal components. In addition, technical professionals must clean the floating dust on the track to increase the lifespan of the automatic induction door and reduce noise. (Technical professionals clean the chassis power supply) IX: Do not place curtains, storage bags, or items that sway with the wind in the area covered by the sensor to avoid jeopardizing the normal operation of the automatic induction door.

　　Regularly clean the chassis power supply and regularly check and maintain the automatic induction door to ensure its normal operation and smoothness.